VisualDSP++ 4.5 Loader and Utilities Manual - Analog Devices

ADSP-2106x/21160 Processor Loader Guide
Table 3-15. ADSP-2106x/21160 Loader Command-Line Switches
(Cont’d)
Switch Description
-l kernelfile Directs the loader utility to use the specified kernelfile as the
boot-loading routine in the output boot-loadable file. The boot kernel
selected with this switch must correspond to the boot type selected with
the -b switch.
If the -l switch does not appear on the command line, the loader
searches for a default boot kernel file. Based on the boot type (-b
switch), the loader utility searches in the processor-specific loader directory
for the boot kernel file as described in “ADSP-2106x/21160 Boot
Kernels” on page 3-16.
-o filename Directs the loader utility to use the specified filename as the name for
the loader output file. If not specified, the default name is inputfile.ldr.
-paddress PROM start address. Places the boot-loadable file at the specified
address in the EPROM.
If the -p switch does not appear on the command line, the loader utility
starts the EPROM file at address 0x0; this EPROM address corresponds
to 0x800000 on ADSP-21060/21061/21062, ADSP-21065L,
and ADSP-21160 processors.
-proc processor Specifies the processor. This a mandatory switch. The processor is
one of the following:
ADSP-21060, ADSP-21061, ADSP-21062, ADSP-21065L, ADSP-21160
3-30 VisualDSP++ 4.5 Loader and Utilities Manual