VisualDSP++ 4.5 Loader and Utilities Manual - Analog Devices

ADSP-2106x/21160 Processor Loader Guide
Table 3-15. ADSP-2106x/21160 Loader Command-Line Switches
(Cont’d)
Switch Description
-v Outputs verbose loader utility messages and status information as the
the utility processes files.
-version Directs the loader utility to show its version information. Type
elfloader -version to display the version of the loader drive. Add
the -proc switch, for example,
elfloader -proc ADSP-21062 -version to display version information
of both loader drive and SHARC loader utility.
Using VisualDSP++ Interface (Load Page)
After selecting a Loader file as the target type on the Project page in VisualDSP++
Project Options dialog box, modify the default options on the
Load: Processor page (also called loader property page). Click OK to save
the selections. Selecting Build Project from the Project menu generates a
loader file. For information relative to a specific processor, refer to the
VisualDSP++ online help for that processor.
VisualDSP++ invokes the elfloader utility to build the output file. The
Load page buttons and fields correspond to loader command-line switches
and parameters (see Table 3-15 on page 3-28). Use the Additional
Options box to enter options that do not have dialog box equivalents.
� For
ADSP-21020 processors, the only permitted boot mode is
JTAG: -bJTAG is automatically entered in the Additional Options
box.
3-32 VisualDSP++ 4.5 Loader and Utilities Manual