VisualDSP++ 4.5 Loader and Utilities Manual - Analog Devices

ADSP-2126x/2136x/2137x Processor Loader Guide
Using ADSP-2126x/2136x/2137x Loader Command
Line
Use the following syntax for the SHARC loader command line.
elfloader inputfile -proc processor -switch [-switch …]
where:
� Command-line
inputfile—Name of the executable file (.dxe) to be processed
into a single boot-loadable file. An input file name can include the
drive and directory. Enclose long file names within straight quotes,
“long file name”.
-proc processor—Part number of the processor (for example,
-proc ADSP-21262) for which the loadable file is built. The -proc
switch is mandatory.
-switch …—One or more optional switches to process. Switches
select operations and boot modes for the loader utility. A list of all
switches and their descriptions appear in Table 5-18 on page 5-44.
switches are not case-sensitive and may be placed
on the command line in any order.
The following command line,
elfloader Input.dxe -bSPIflash -proc ADSP-21262
runs the loader utility with:
Input.dxe—Identifies the executable file to process into a
boot-loadable file. Note that the absence of the -o switch causes the
output file name to default to Input.ldr.
5-42 VisualDSP++ 4.5 Loader and Utilities Manual