VisualDSP++ 4.5 Loader and Utilities Manual - Analog Devices

Blackfin Processor Loader Guide
Table 2-10. Blackfin Loader Command-Line Switch Summary (Cont’d)
Switch Description
-v The -v switch directs the loader utility to output verbose loader
messages and status information as the loader processes files.
-waits # The -waits # switch specifies the number of wait states for external
access. Valid inputs are 0 through 15. Default is 15. Wait states
apply to the flash/PROM boot mode only.
� Currently
is applicable to ADSP-BF535 processors
only.
-width # The -width # switch specifies the loader output file’s width in bits.
Valid values are 8 and 16, depending on the boot mode. The default
value is 16 for FIFO boot mode and 8 for all other boot modes.
On ADSP-BF535 processors, the switch has no effect on boot kernel
code processing. The loader utility processes the kernel in 8-bit
widths regardless of the output width selection.
For flash/PROM booting, the size of the output file
depends on the -width # switch.
For FIFO booting, the only available width is 16.
For SPI booting, the size of the output .ldr file is the
same for both -width 8 and -width 16. The only difference
is the header information.
2-72 VisualDSP++ 4.5 Loader and Utilities Manual