VisualDSP++ 4.5 Loader and Utilities Manual - Analog Devices

Table 2-11. Base Load Page Settings (Cont’d)
Setting Description
Loader/Splitter for Blackfin Processors
Wait state Specifies the number of wait states for external access (0–15).
The selection is active for ADSP-BF535 processors. For
ADSP-BF531/BF532/
BF533/BF534/BF536/BF537/BF538/BF539/BF561/BF566 processors,
the field is grayed out.
Hold time Specifies the number of the hold time cycles for PROM/flash boot (0–
3).
The selection is active for ADSP-BF535 processors. For
ADSP-BF531/BF532/
BF533/BF534/BF536/BF537/BF538/BF539/BF561/BF566 processors,
the field is grayed out.
Baud rate Specifies a baud rate for SPI booting (500 kHz, 1 MHz, and 2 MHz).
The selection is active for ADSP-BF535 processors. For
ADSP-BF531/BF532/
BF533/BF534/BF536/BF537/BF538/BF539/BF561/BF566 processors,
the field is grayed out.
Programmable flag Selects a programmable flag number (from 0 to 15) as strobe. This box
is active if SPI Slave is selected for
ADSP-BF531/BF532/BF533/BF534/BF536/BF537/ BF538/BF539
processors.
Initialization file Directs the loader utility to include the initialization file (Init code).
The Initialization file selection is active for
ADSP-BF531/BF532/BF533, and ADSP-BF561 processors. For
ADSP-BF535 processors, the field is grayed out.
Kernel file Specifies the boot kernel file. Can be used to override the default boot
kernel if there is one by default, as on ADSP-BF535 processors.
Output file Names the loader utility’s output file.
Additional options Specifies additional loader switches. You can specify additional input
files for a multi-input system. Type the file names with the paths (they
are not in the current working directory) separated with a space between
two names, and the loader utility will retrieve these input files.
Note: The loader utility processes the input files in the order in which
the files appear on the command line generated form the property page.
VisualDSP++ 4.5 Loader and Utilities Manual 2-75