VisualDSP++ 4.5 Loader and Utilities Manual - Analog Devices

ADSP-21161 Processor Loader Guide
-bSPI—Specifies SPI port booting as the boot type for the
boot-loadable file.
-proc ADSP-21161—Specifies ADSP-21161 as the target processor.
Multiprocessor Systems
The following command line,
elfloader -proc ADSP-21161 -bprom -id1exe=Input1.dxe
-id2exe=Input2.dxe
runs the loader utility with:
-proc ADSP-21161—Specifies ADSP-21161 as the target processor.
-bprom—Specifies EPROM booting as the boot type for the
boot-loadable file.
-id1exe=Input1.dxe—Identifies Input1.dxe as the executable file
to process into a boot-loadable file for a processor with ID of 1 (see
“Processor ID Numbers” on page 4-23).
-id2exe=Input2.dxe—Identifies Input2.dxe. as the executable file
to process into a boot-loadable file for a processor with ID of 2 (see
“Processor ID Numbers” on page 4-23).
4-26 VisualDSP++ 4.5 Loader and Utilities Manual