VisualDSP++ 4.5 Loader and Utilities Manual - Analog Devices

� Most
Splitter for SHARC and TigerSHARC Processors
-s section_name—The -s switch can be used without the -pm, -dm,
or -64 switch. The splitter command line must include one or
more of the -pm, -dm, and, -64 switches or the -s switch.
items in the splitter command line are not case sensitive; for
example, -pm and -PM are interchangeable. However, the names of
memory sections must be identical, including case, to the names
used in the executable.
Each of the following command lines,
elfspl21k -pm -o pm_stuff my_proj.dxe -proc ADSP21161
elfspl21k -dm -o dm_stuff my_proj.dxe -proc ADSP21161
elfspl21k -64 -o 64_stuff my_proj.dxe -proc ADSP21161
elfspl21k -s seg-code -o seg-code my_proj.dxe
runs the splitter utility for the ADSP-21161 processor. The first command
produces a PROM file for program memory. The second command produces
a PROM file for data memory. The third command produces a
PROM file for DATA64 memory. The fourth command produces a PROM
file for section seg-code.
The switches on these command lines are as follows.
-pm
-dm
-64
Selects program memory (-pm), data memory (-dm), or DATA64 memory
(-64) as sources in the executable for extraction and placement into the
image. DATA64 memory does not apply to ADSP-2106x processors.
Warning: The -pm, -dm, or -64 switch does not apply to ADSP-TSxxx
processors.
Because these are the only switches used to identify the memory source,
the specified sources are PM, DM, or DATA64 memory sections. Because
no other content switches appear on these command lines, the output
file format defaults to a Motorola 32-bit format, and the PROM word
width of the output defaults to 8 bits for all PROMs.
VisualDSP++ 4.5 Loader and Utilities Manual 7-3