BSA Flow Software Installation and User's Guide - CSI

Select the type of the files to open a project (*.lda) or a compressed project
(*.ldz). In case of a compressed project, BSA Flow is going to uncompress it
automatically.
4. Open a file in the list. The program will now open the workspace as it
was saved.
5. In the toolbar, click on the Load button .
6. The software now loads the data from disk and updates the objects in the
project.
7. Click on the histogram window. It displays the histogram of the last
position.
To select another position, right-click the Histogram object in the project
explorer, and click Select position in the drop-down menu.
Unselect All available positions and type in the number of the position
you want to get a histogram from (according to its number in the list in
the mesh). This will update the histogram with data from that position.
In the tool bar, there are buttons for “Previous position” and "Next
position". This will display the histogram from the previous position (in
the same order as shown in the measurement positions table in the BSA
Application window).
8. All views representing data from a single position can be updated as
described above (lists, histograms, spectrum or correlation graphs, time
series graphs, etc.)
New objects can be added to existing objects by clicking the “new object”
button in the toolbar, or by right-mouse-clicking on an existing object. The
prerequisite is that it is meaningful to add an object. It is not possible to add
new objects to graph or list objects.
BSA Flow Software: The user interface 4-67