BSA Flow Software Installation and User's Guide - CSI

1.3 Laser safety
All equipment using lasers must be labeled with the safety information.
Dantec FiberFlow and FlowLite systems use class III and class IV lasers
whose beams are safety hazards. Please read the laser safety sections of the
documentation for the laser and LDA optics carefully. Furthermore, you
must instigate appropriate laser safety measures and abide by local laser
safety legislation. Use protective eye wear when the laser is running.
Danger laser light Laser light is a safety hazard and may harm eyes and skin. Do not aim a
laser beam at anybody. Do not stare into a laser beam. Do not wear
watches, jewellery or other blank objects during alignment and use of the
laser. Avoid reflections into eyes. Avoid accidental exposure to specular
beam reflections. Avoid all reflections when using a high-power laser.
Screen laser beams and reflections whenever possible. Follow your local
safety regulations. You must wear appropriate laser safety goggles during
laser alignment and operation.
During alignment, run the laser at low power whenever possible.
Since this document is concerned with the BSA Flow Software, there is no
direct instructions in this document regarding laser use. Therefore, before
connecting any laser to the system, you must consult the laser safety section
of the laser instruction manual.
Precautions As general precautions to avoid eye damage, carefully shield any reflections
so that they do not exit from the measurement area.
LASER RADIATION
AVOID DIRECT EXPOSURE TO BEAM
HELIUM-NEON 10 mW
CLASS III b LASER PRODUCT
AVOID EXPOSURE - LASER RADIATION
IS EMITTED FROM THIS APERTURE
BSA Flow Software: General 1-9