BSA Flow Software Installation and User's Guide - CSI

Figure 6-11. Modifying the plot style.
If you check the Line box the data-samples will be connected with lines of
colour, linestyle and thickness corresponding to the user selections made.
Blank values In some cases the value “not a number” is associated with a variable. In such
cases the 2D Plot and Profile Plot will not draw a line between data points,
even if Line is selected in the dialog shown in Figure 6-11. As an example,
see Figure 6-12. This shows mean velocity vs. angular position of a fan
impeller, for data measured between the blades. At three angular positions,
the fan blades blocked the laser beams, so no data were acquired.
Figure 6-12. 2D Plot with blank values.
If you check the Point box each sample will be shown with a marker of
colour, type and size corresponding to user the selections made.
Finally checking the box Use as default style, will change the default
settings of the style in question to correspond to the selections just made.
This way you need not make the same changes over and over, if you have
some preferred settings.
Plot Template If your preferred settings involve more than colours and linestyles, you can
save an entire plot as a template including all property settings. Templates
are described in more details elsewhere in the manual.
None of the changes will take effect until you press OK, while pressing
Cancel will ignore the changes, and close the dialog.
6-10 BSA Flow Software: Options and Add-ons