BSA Flow Software Installation and User's Guide - CSI

Warning Please observe strict security rules when operating the LDA or PDA system
remotely to avoid injury and eye damage:
An Emergency Stop button must be accessible near the traverse system.
The room with the measurement system must be locked, or the measurement
system must be shielded to avoid that a person can approach it .
A flashing warning light should indicate that the system is running.
Please observe laser safety rules as well, see chapter 1.
Set-up of the local PC
Set-up for remote operation is chosen in the Dantec Device Configuration:
On the local PC, select Traverse System and click on Properties
To enable remote control of the traverse, check the Use TCP/IP Network
box and specify the Address of the remote PC, either with the PC’s name
on the network, or with it’s IP-address.
If you do not know the IP address of the remote PC, please follow the steps
explained in section 0
Finding the IP address or name of the remote PC
IP adress: If you do not know the IP address of the remote PC, you can do the
following:
On the remote PC, click Windows’ Start button – select Run… and type cmd
in the command line to start a command window. Type ipconfig to get
information about the IP address. Type the IP address in the Address field in
the above dialog box.
Name: To find the name of the PC, go to the Windows Control Panel couble-click
the System icon – select the Network Indentification tab to see the Full
computer name and domain. The full computer name includes the domain
name, e.g. LDAXP.dantecdynamics.com, where dantecdynamics.com is the
domain name.
BSA Flow Software: Project explorer objects 5-47