BSA Flow Software Installation and User's Guide - CSI

5.9 Export
Figure 5-40 Data-sources for coincidence filtering.
If Import velocity files is used as data-source, arrival time must be available
and included in the import operation for the coincidence object to work.
The property editor of this object contains two properties:
Figure 5-41 Property editor of the coincidence object.
The property Record interval window describes the largest acceptable time
difference between velocity samples in the velocity channels. If the arrival
times differ by more than this, the samples are not considered coincident,
and the software will attempt to find a better match.
The property Coincidence mode is always User set. The user must
manually enter the Record interval window. An appropriate value is the
measurement volume diameter divided by the highest velocity present in the
flow.
Like the List object, Export is a general purpose object which can be used to
export, online or after the measurements, data from any object supplying
data. Consequently any data that can be listed can also be exported.
Blank values Blank values are exported as #N/A, which is understood by most Windows
programs.
Exporting from a single
position Right-click on an object like a list or Histogram to export data from it. This
requires manual interaction for each file to be exported. For further
information about exporting plots, please refer to chapter 6 Exporting plots.
BSA Flow Software: Project explorer objects 5-49