BSA Flow Software Installation and User's Guide - CSI

Caution The optical fibre must not be folded or twisted. It will be damaged. .
4.10.2 Configuring an LDA or PDA system
After installation of the Ethernet card and the BSA Flow Software:
1. Go to “Start”, “Settings”, “Control Panel”
2. Open “Network Dial-up Connections”
3. Right mouse click on Local Area Connection, open “Properties”
4. Click on TCP/IP, then “Properties”, click on “Use following IP address”
5. Enter: IP address 10.10.100.25 Subnet mask 255.0.0.0
6. Click “OK” and you may need to restart the computer.
7. Turn on the BSA processor and wait for the “ready” light to come on.
8. Open “Control panel” and click on the Dantec Device Configuration Icon.
9. A “wizard” may run and fail to find the BSA processor, click on OK and
click on “Add”, then “Processor”, “OK”.
10. Click on processor, then properties, set TCP/IP to 10.10.100.100
11. Click on “information”, “update”, processor should then be found and
connected.
12. Click on “optics”, set-up either LDA or PDA optical system and optical
configuration can then be set.
13. BSA software can now be run.
After installation of the BSA Flow software and interfaces, a system
configuration must be defined in the PC. The is done from the toolbar:
or from the Windows Control Panel by double clicking on the Dantec
Device Configuration icon:
This opens the following window:
4-34 BSA Flow Software: The user interface