BSA Flow Software Installation and User's Guide - CSI

Pin Signal Pin Signal
1 Out 1 14 Ground
2 Out 2 15 Ground
3 Out 3 16 Ground
4 DSUB 1 17 Ground
5 DSUB 2 18 Ground
6 DSUB 3 19 Ground
7 DSUB 4 20 Ground
8 Differential 1 - 21 Ground
9 Differential 1 + 22 Ground
10 Differential 2 - 23 Ground
11 Differential 2 + 24 Ground
12 Differential 3 - 25 + 5 Volt
13 Differential 3 +
6.2.3 Sync. Input Signals properties
Table 6-3 Pin assignments on the S1 connector
Cyclic phenomena data can be sorted either according to the time passed
from the last reset, or according to the physical angle of rotation of an
encoder.
To sort according to time, use the Sync. 1 for a reset pulse (once per cycle
pulse) . Bursts will be stamped with the time from the last Sync. 1 pulse.
To sort according to physical angle using an encoder, use Reset Encoder and
Encoder. Bursts will be stamped with the encoder count from the last Reset
Encoder pulse.
It is possible to map the same inputs both to the Sync.1, Sync. 2 and to the
Reset Encoder and Encoder inputs. In this case, each burst will have an
arrival time and an encoder count associated, and each Sync pulse will be
time stamped.
BSA Flow Software:Options and Add-ons 6-35