AT Commands Reference Manual - wireless netcontrol GmbH

Call Control
• Not provisioned (CLIR Off - presentation allowed)
• Provisioned permanently
• Provisioned with Temporary mode
The provision is fixed and cannot be changed by an AT command.
Temporary Mode:
Temporary mode can be in one of two states:
• A - Presentation restricted (CLIR On) as default.
• B - Presentation allowed (CLIR Off) as default. A subscriber to Temporary mode always has
a default subscription to state A or B. Temporary-mode provisioning means that the terminal
can request the H24 to switch the default mode from A to B, and vice versa.
Note: When a service is in state A, and the terminal wants to enable the CLI presentation (turn
CLIR off) for a single call, it can do so using the ATD command. This does not change
the Temporary mode state. This can also be done when the service is in state B and the
terminal wants to disable the CLI presentation (turn CLIR on) for a single call.
Command
Type
Syntax Response/Action Remarks
Set +CLIR= OK The Set command instructs the H24 to
enable/disable CLI restriction for all MO
calls.
Read +CLIR? +CLIR:,
OK
Test +CLIR=? +CLIR: (list of supported
s)
The Read command returns the current
setting of CLIR on the network and
on the H24 .
The Test command returns values
supported by the H24.
The following table shows the +CLIR parameters.
Table 3-13: +CLIR Parameters
Description
Adjustment for outgoing calls
0 - Presentation indicator is used according to the subscription of the CLIR service
1 - CLIR invocation
2 - CLIR suppression
The default is 2.
Subscriber CLIR service status in the network
0 - CLIR not provisioned
1 - CLIR provisioned in permanent mode
2 - Unknown (for example, no network and so on)
3 - CLIR Temporary mode presentation restricted (can be the default)
4 - CLIR Temporary mode presentation allowed (can be the default)
3-32 H24 - AT Commands Reference Manual April 15, 2010