14.03.2015 Views

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Modem Configuration and Profile<br />

Sleep <strong>Commands</strong> Description<br />

+MSLEEP, Enable/Disable Sleep Mode<br />

This command enables or disables the H24 to enter Sleep Mode.<br />

The value at power up is H24 Sleep Mode disabled.<br />

Command Type Syntax Response/Action Remarks<br />

Set <strong>AT</strong>+MSLEEP= 1 OK<br />

ERROR<br />

or:<br />

+CME ERROR:<br />

Read <strong>AT</strong>+MSLEEP? 2<br />

OK<br />

Test <strong>AT</strong>+MSLEEP=? +MSLEEP: (0-1)<br />

OK<br />

Note: 1 ) The set command sets the status of the Sleep Mode [enabled/disabled].<br />

2 ) The read command returns the current status of the Sleep Mode.<br />

The following table shows the +MSLEEP parameters.<br />

Table 3-171: +MSLEEP Parameters<br />

<br />

<br />

Description<br />

This parameter enables/disables the Sleep Mode.<br />

0 Disabled (H24 does not enter Sleep Mode, the H24 stay active all time).<br />

1 Enable the H24 to enter to Sleep Mode.<br />

The default value is 0.<br />

The value does not save in NV, means that after power up it will be always 0 (disable).<br />

Example<br />

<strong>AT</strong>+MSLEEP=?<br />

+MSLEEP: (0-1)<br />

OK<br />

<strong>AT</strong>+MSLEEP?<br />

+MSLEEP: 0<br />

OK<br />

<strong>AT</strong>+MSLEEP=1<br />

OK<br />

3-254 H24 - <strong>AT</strong> <strong>Commands</strong> <strong>Reference</strong> <strong>Manual</strong> April 15, 2010

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!