AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Summary
&D
+MCWAKE
+CFUN
+ICF
+IFC
This command determines how the H24 responds when the DTR
(Data Terminal Ready) status is changed from ON to OFF during
the online data state.
This command displays reports on the status of the GPRS/GSM
coverage.
This command shuts down the phone functionality of smart phones
and PDAs with phone capabilities.
This command determines the local serial port start/stop
(asynchronous) character framing used by the DCE when accepting
DTE commands and transmitting information text and result codes.
This parameter controls the operation of the local flow control
between the terminal and the H24 during the data state when V.42
error control is used, or when fallback to non- error control mode is
specified to include buffering and flow control.
Page 3-163
Page 3-164
Page 3-166
Page 3-168
Page 3-169
+MIOC This command defines the H24 8 GPIO pins data value. Page 3-171
+MIOD This command defines the H24 8 GPIO pins configuration. Page 3-173
+MIOI
+MPCMC
Table 1-1: AT Commands (Cont.)
AT Command Description Page
This command supports the H24 8 GPIO pins configuration as
interrupt lines.
This command defines whether the PCM clock is generated
continuously or not, when module is in digital audio mode.
Page 3-176
Page 3-178
+MVREF This command defines the behavior of Vref regulator. Page 3-180
+MFTM This command is used to enter and exit FTM mode. Page 3-181
+TGFCC This command defines RF parameters for signal transmission. Page 3-182
+TWFCC This command defines RF parameters for signal transmission. Page 3-186
+MPWRDN
+MRST
+MTMP
This command enables the customer software to perform a power
down to the H24 unit.
This command enables the customer software to perform a hard
reset to the H24 unit.
This command enables a user to query the temperature level in
Celsius degrees.
Page 3-189
Page 3-189
Page 3-189
Antenna Physical Connection Detection
+MUANTYPED
ET
This command allows recognizing the attached antenna type. Page 3-190
+MUANTYPE This command sets the user antenna type used. Page 3-191
ATS97
Audio
This command indicates the status of the antenna physical
connection to the H24 RF connector.
Page 3-192
Standard Audio Commands
1-24 H24 - AT Commands Reference Manual April 15, 2010