AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
+MIPSEND, Add Data to Socket
This command sends data from the terminal to the module and causes the module to accumulate
the data in the socket. The data will be automatically sent to Network once, when accumulated
data reaches the predefined watermark or timeout occurs (see “+MIPSETS, Set Watermark and
Timeout for Automatic Push” on page 3-325).
Motorola recommends to set the watermark prior to +MIPSEND command usage.
Command Type Syntax Response/Action Remarks
Set AT+MIPSEND =
, 1
OK
+MIPSEND:
,,
Or
ERROR [] 2
Read AT+MIPSEND? +MIPSEND: ,
[+MIPSEND:
,] 3
...
OK
Test AT+MIPSEND=? +MIPSEND: (list of supported
's),
()
OK
Note: 1 ) Data in the Set command is limited to 160 ASCII characters (encoded), see MIP
Commands Using Cases / Data Encoding for more description.
2 ) The Set command returns an ERROR indication when the command process fails (see
Table 3-218). ErrorCode is returned when numeric/verbose responses mode is enabled.
3 ) The Read command returns a report for all active sockets.
April 15, 2010 H24 - AT Commands Reference Manual 3-327