AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
Only one ping request execution will be allowed at any given moment.
Command Type Syntax Response/Action Remarks
Set
+MPING=[,,
[,][,
][,][,]]
OK
or:
+CME ERROR:
The set command
shall send a
Internet Control
Message Protocol
(ICMP) Echo Request
messages to a target
node defined by
Parameter, over an
active .
If is equal 0,
no parameters trailing
parameter
are allowed,
otherwise ERROR
message will be
reported to DTE. If
is equal 0,
MS will abort sending
Echo Request
messages if ping
request is in process,
otherwise ERROR
message will be
reported to DTE.
Unsolicited
Response
+MPING: ,
The receipt of
corresponding ICMP
Echo Reply messages
will be displayed
within unsolicited
responses, along with
round trip times.
Read +MPING? +MPING: ,,
,,
OK
Test +MPING=? +MPING: (List of supported
s),(Range of s),(Range
of s),(Range of s), ( Range
of s)
OK
The read command
displays currently
selected parameters
values for +MPING
set command. If ping
sending procedure is
currently in process
then user selected
parameters for
AT+MPING
command will be
displayed, otherwise
default parameter
values will be
displayed.
The test command
displays all supported
parameters values for
+MPING set
command.
April 15, 2010 H24 - AT Commands Reference Manual 3-343