AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Alphabetical Summary
+MGSMSIM
This command adjusts the H24 to work with a 2G SIM or a 3G SIM
card types.
Page 3-225
+MIND This command enables/disables some user indications to the TE. Page 3-276
+MIOC This command defines the H24 8 GPIO pins data value. Page 3-171
+MIOD This command defines the H24 8 GPIO pins configuration. Page 3-173
+MIOI
+MIPCALL
+MIPCLOSE
+MIPCONF
+MIPCSC
+MIPDATA
+MIPFLUSH
+MIPOPEN
+MIPPUSH
+MIPRTCP
+MIPRUDP
+MIPSEND
+MIPSETS
+MIPSSL
+MIPSTAT
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
This command supports the H24 8 GPIO pins configuration as
interrupt lines.
This command creates a wireless PPP connection with the GGSN or
CSD service provider and returns a valid dynamic IP for the H24.
This command causes the H24 module to free the socket
accumulating buffer and disconnect the H24 from a remote side.
This command allows to configure TCP stack parameters, such as
retransmissions number, upper and bottom limits of retransmission
timeout, close delay. It can be used to configure TCP socket
parameters before socket activation or when the socket is in active
state.
This AT command is used to configure the SSL feature behavior in
case of non - fatal alerts.
This unsolicited event is sent to the terminal indicating a data
comes from Network when H24 is in pseudo-command
mode.
This command causes the H24 module to flush (delete) data
accumulated in its accumulating buffers.
This command causes the H24 module to initialize a new socket and
open a connection with a remote side.
This command causes the H24 module to push the data accumulated
in its accumulating buffers into the protocol stack.
This unsolicited event is sent to the terminal when data is received
from the TCP protocol stack.
This unsolicited event is sent to the terminal when data is received
from the UDP protocol stack.
This command causes the H24 to transmit the data that the terminal
provides, using an existing protocol stack.
This command causes the H24 to set a watermark in the
accumulating buffer. When the watermark is reached, data is pushed
from the accumulating buffer into the protocol stack.
This unsolicited event is sent to the terminal indicating an errors,
warnings or alerts that occurred during SSL connection.
This unsolicited event is sent to the terminal indicating a change in
link status.
Page 3-176
Page 3-315
Page 3-323
Page 3-333
Page 3-348
Page 3-341
Page 3-331
Page 3-318
Page 3-329
Page 3-339
Page 3-340
Page 3-327
Page 3-325
Page 3-350
Page 3-340
+MIPXOFF This unsolicited event is sent to the terminal to stop sending data. Page 3-338
A-8 H24 - AT Commands Reference Manual April 15, 2010