AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
&W, Store User Profile
This command stores the user profile configuration to the NV. The H24 supports 2 user profile
values, the default profile is 0.
Command Type Syntax Response/Action Remarks
Set &W[] OK
or
+CME ERROR:
The Set command stores the current
active configuration to user profile 0 or
1.
The following table shows the &W parameters.
Table 3-168: &W Parameters
Description
User's profile number:
0 Store to user's profile 0
1 Store to user's profile 1
The default value is 0.
The parameters that are set in a profile are described in the table below.
Table 3-169: Profile Parameters
Profile
Parameter
Description
Parameter
Range
Default Value
Length in
Bits
ATE Echo. 0-1 1 1
ATQ Result code return mode. 0-1 0 1
ATV Display result code. 0-1 1 1
ATX Select result code. 0-4 0 3
AT&C Set circuit 109 (DCD) behavior. 0-2 0 2
AT&D Set circuit 109 (DTR) behavior. 0-4 2 3
AT&K Flow control. 0, 3-6 3 3
AT&Y Power-up profile. 0-1 0 1
S0 Auto-answer. 0-255 0 8
S2 Escape code character. 0-255 43 8
S3 Carriage return character. 0-127 13 7
S4 Line feed character. 0-127 10 7
S5 Backspace character. 0-32 8 6
April 15, 2010 H24 - AT Commands Reference Manual 3-249