AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
Table 3-53: +CNMI Parameters (Cont.)
Description
Determines SMS-STATUS-REPORTs indication report:
0 No SMS-STATUS-REPORTs indications are routed to the TE (default)
1 SMS-STATUS-REPORTs are routed directly to the TE using the following
un-solicited result code (+CDS parameters are described in Table 3-58):
PDU Mode:
+CDS:
Text Mode:
+CDS: ,,[],[],,,
2 If SMS-STATUS-REPORT is stored in the ME/TA, indication of the memory
location is routed to the TE using unsolicited result code (+CDSI parameters are
described in Table 3-57):
+CDSI: ,
Handles buffering result codes:
0 TA buffer of unsolicited result codes defined within this command is flushed to
the TE when 1,2 is Entered (default).
1 TA buffer of unsolicited result codes defined within this command is cleared
when 1,2 is entered.
Memory storage where the new message is stored according to +CPMS
settings, i.e. "SM" or "ME".
Index where short message as been stored in .
Note: Buffer can hold up to 15 SMSs indications.
Example
See +CMT, +CMTI, +CDS and +CDSI examples.
+CNMA, New Message Acknowledgment
This command allows acknowledgement of received incoming SMS-DELIVER (+CMT) or
SMS-STATUS-REPORT (+CDS) routed directly to TE when +CSMS command =1.
In case acknowledge is not send within required time, an RP-ERROR is send to network, +CNMI
parameters and are clear and next incoming SMS indication is disable.
In TEXT mode, only positive acknowledgement to the network (RP-ACK) is possible.
April 15, 2010 H24 - AT Commands Reference Manual 3-93