AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
The following table shows the +CGEQMIN command parameters.
Table 3-197: +CGEQMIN Command Parameters
Description
A numeric parameter that specifies a particular PDP
context definition.
The supported values are: 1 to 16.
Numeric parameter that indicates the type of
application for which the EDGE bearer service is
optimized.
0 - conversational
1 - streaming
2 - interactive
3 - background
4 - subscribed value
If the Traffic class is specified as conversational or
streaming, then the Guaranteed and Maximum bit rate
parameters should also be provided.
Numeric parameter that indicates the maximum number
of kbits/s delivered to UMTS/EDGE (up-link traffic) at
a SAP. As an example a bit rate of 32kbit/s would be
specified as '32' (e.g. AT+CGEQMIN =…,32, …). If
the parameter is set to '0' the subscribed value will be
requested. This parameter should be provided if the
Traffic class is specified as conversational or streaming.
The supported values are: 0 to 5760.
Numeric parameter that indicates the maximum number
of kbits/s delivered by UMTS/EDGE (down-link
traffic) at a SAP. As an example a bit rate of 32kbit/s
would be specified as '32' (e.g. AT+CGEQMIN=…,32,
…). If the parameter is set to '0' the subscribed value
will be requested. This parameter should be provided if
the Traffic class is specified as conversational or
streaming.
The supported values are: 0 to 7168.
Numeric parameter that indicates the guaranteed
number of kbits/s delivered to UMTS/EDGE (up-link
traffic) at a SAP (provided that there is data to deliver).
As an example a bit rate of 32kbit/s would be specified
as '32' (e.g. AT+CGEQMIN=…,32, …). If the
parameter is set to '0' the subscribed value will be
requested. This parameter should be provided if the
Traffic class is specified as conversational or streaming.
The supported values are: 0 to 5760.
April 15, 2010 H24 - AT Commands Reference Manual 3-311