AT Commands Reference Manual - wireless netcontrol GmbH

Modem Configuration and Profile
Table 3-169: Profile Parameters (Cont.)
Profile
Parameter
Description
Parameter
Range
Default Value
Length in
Bits
S7
Wait time for a remote data
adaptor's carrier signal before
hanging up.
1-90 30 8
S8 Timer to send DTMF. 0-255 2 8
S12
S24
S100
S102
Time (in units of 50 ms) for the
escape character during CSD
connections.
Time, in seconds to wait before
entering Sleep mode.
Value of the delay before sending
data to the terminal.
Minimum Time for Terminal to
Fall into Sleep Mode.
0-255 20 8
1-255 3 8
0-255 0 8
0-255 0 8
Example
AT&W0
OK
AT&W1
OK
&Y, Default User Profile
This command sets the user profile to the power up configuration. The H24 supports 2 user
profile values, the default profile is 0.
Command Type Syntax Response/Action Remarks
Set &Y[] OK
or
+CME ERROR:
The Set command stores the current
active configuration to user profile 0 or
1.
The following table shows the &Y parameters.
Table 3-170: &Y Parameters
Description
User's profile number:
0 Selects power-up configuration to user's profile 0
1 Selects power-up configuration to user's profile 1
The default value is 0.
3-250 H24 - AT Commands Reference Manual April 15, 2010