AT Commands Reference Manual - wireless netcontrol GmbH

Hardware Information
The following table shows the +MIOC parameters.
Table 3-104: +MIOC Parameters
Description
Selected pins for the action invoked. This is a binary vector in which each bit points to
pin number. Vector size is 8.
0 Not selected
1 Selected pin (default)
This is a binary vector in which each bit show the physical value of pin. Data vector
size is 8.
0 Physical low signal.
1 Physical high signal.
The default value:
On Power Up - as previously saved in FLEX bytes.
Before set command first used with and =0, or after +MIOC
without and before +MIOC command used - 1.
Note: GPIO data will not be saved in case of a power cut.
Example
AT+ MIOC=?
+ MIOC: (00000000-11111111),(00000000-11111111)
OK
AT+ MIOC?
+ MIOC: 1,1,0,0,0,0,0,0 // actual logical value of the 8 GPIO pins.
OK
3-172 H24 - AT Commands Reference Manual April 15, 2010