14.03.2015 Views

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Chapter 3: <strong>AT</strong> <strong>Commands</strong> <strong>Reference</strong><br />

+CBC: 0,60 //This example shows 0 (battery powered) with 60% power.<br />

OK<br />

Note: The battery level is an average value, which is updated once in 0.5 minute max,<br />

depending on unit state "Idle" or "In-call or searching" accordingly.<br />

All values are on the 70 pin connector. Preciseness is (+/-) 50mV.<br />

+CBAUD, Baud Rate Regulation<br />

This command sets the baud rate. The baud rate of the H24 is changed/set to the request value<br />

written in the command.<br />

The UART is configured according to the request, or to the specific constant baud rate after<br />

output "OK" response to the terminal. For example, <strong>AT</strong>+CBAUD=8 is equivalent to<br />

<strong>AT</strong>+CBAUD=57600.<br />

Note: This command can only be issued over UART.<br />

For Circuit Switched Data calls, baud rate must be set higher than the network's rate.<br />

Command Type Syntax Response/Action<br />

Set<br />

<strong>AT</strong>+CBAUD=<br />

<strong>AT</strong>+CBAUD=<br />

OK<br />

or:<br />

ERROR<br />

Read <strong>AT</strong>+CBAUD? +CBAUD: <br />

Test <strong>AT</strong>+CBAUD=? +CBAUD: (list of supported s, list of<br />

supported s)<br />

April 15, 2010 H24 - <strong>AT</strong> <strong>Commands</strong> <strong>Reference</strong> <strong>Manual</strong> 3-157

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!