AT Commands Reference Manual - wireless netcontrol GmbH

Call Control
AT+MFIC?
+MFIC: 0,"SM"
OK
//Read MFIC parameters.
AT+MFIC=1
OK
//Enable the MFIC Voice Call feature.
AT+MFIC?
+MFIC: 1,"SM"
OK
//Read MFIC parameters.
AT+CPBS="ME"
OK
//Change the phone book storage to ME storage.
AT+CPBW=1,"+972545658279"
OK
//Save the sending phone number in the phone book.
//Call from +972545658279
RING
RING
//Call is accepted
//Call from +97254555555.
//Call from +97254555555 is dropped.
+CBST, Select Bearer Service Type
This command sets the bearer service (data circuit duplex asynchronous and synchronous). It
chooses one of the bearer services, the data rate of the service (actually the modulation when
modem IWFs are used), and enables or disables the Radio Link Protocol.
Note: For Circuit Switched Data calls, baud rate must be set higher than the network's rate.
Command
Type
Syntax Response/Action Remarks
Set
AT+CBST=[[,<
name>
[,]]]
OK
+CME ERROR:
The Set command selects the bearer
service with data rate
and the connection element to be
used when data calls are originated.
Note: For incoming calls, the bearer
service will be taken
automatically from incoming
parameters and not according
to the CBST Set command.
3-36 H24 - AT Commands Reference Manual April 15, 2010