AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
The following table shows the +MGPSLOC parameters.
Table 3-226: +MGPSLOC Parameters
Description
0 - Disable MGPSLOC unsolicited indication (default).
1 - Enable MGPSLOC unsolicited indication.
The default value is 0.
1-3600 - Desired Interval in Sec. Desired Time
difference to the next unsolicited position indication
starting the last unsolicited report.
Note: Once unsolicited position indication is reported,
H24 starts a timer of number of
second, once timer expires H24 requests position
from its GPS engine, normally H24 will get the
position and report it within 1 second (in case h24
is in hot state). However due to specific QoS
setup by the user or other objective reason it may
take more. This is why the interval can NOT be
defined as fixed interval, but more of desired
interval.
Default value: 1.
0 - Disable NMEA messages streaming via NMEA
defined path.
1 - Enable NMEA messages streaming via NMEA
defined path.
Day: 1..31
Month: 1..12
Year: yyyy
Hours: 0..23
Minutes: 0..59
Seconds: 0..59
Note: Time is represented in UTC.
Latitude: -324,000,000..324,000,000 (-90?.. 90?)
Longitude: -648,000,000..648,000,000 (-180?.. 180?)
Altitude in meters:?
Velocity in 0.25 m/s
0..3599
Number of Visible Satellites 0..12
Position DOP - poor quality (DOP>8)
Fix Type: 0 - No Fix
1 - 2D Fix
2 - 3D Fix
Note: 1. When AT+MGPLOC unsolicited indications are enabled, AT+MNMEA set command
is not allowed.
2. Set command is NOT allowed until response for Execute command is received
(single shot location message is displayed).
3. In the case of NMEA messages enabled through parameter, NMEA
messages will be output to defined NMEA path every one second until H24 reaches
April 15, 2010 H24 - AT Commands Reference Manual 3-363