AT Commands Reference Manual - wireless netcontrol GmbH

GPRS/EDGE/UMTS
The following table shows the command's parameters and returned results.
Table 3-198: +MIPCALL Parameters
CallID
operation
CID
Description
A unique number that identifies a call in 0-2 range. Call ID value in 1-2 range
represents a valid Call ID and can be used for +MIPCALL set command type. Call ID
value 0 is used in +MIPCALL read command type and responses, when no active call
found.
0 - close a Network Call
1 - open a Network Call
2 - open a Circuit Switched Call 1
PDP Context Identifier in 0-16 range. 1-16 range is valid PDP CID values, 0 - value
represents invalid CID 2 .
Phone Number Phone number of CSD service provider (in quotation marks) 3 up to 64 characters. 1
Local IP
Call Status
IP address given by the network service provider.
0 - Closed
1 - Opened
Note: 1 ) The feature will be implemented later.
2 ) Zero CID value will be used in
+MIPCALL command set case as CID parameter when CSD based call activation
requested.
+MIPCALL command read case, when CSD-based active call found.
3 ) Contact your service provider for details.
Example
AT+MIPCALL?
+MIPCALL: 0,0
AT+MIPCALL=1,1,1
OK
+MIPCALL: 1,1,"172.16.157.152"
AT+MIPCALL=2,1,2
OK
+MIPCALL: 2,1,"172.16.1.34"
AT+MIPCALL?
+MIPCALL: 1,1,"172.16.157.152"
+MIPCALL: 2,2,"172.16.1.34"
OK
3-316 H24 - AT Commands Reference Manual April 15, 2010