AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
Table 3-188: +CGDCONT Parameters (Cont.)
Description
String parameter (in quotation marks), which identifies the ME in the address space
applicable to the PDP.
If the value is null or omitted, a value may be provided by the terminal during the
PDP startup procedure or, failing that, a dynamic address is requested.
The Read form of the command continues to return the null string even if an address
has been allocated during the PDP startup procedure. The allocated address may be
read using the +CGPADDR command.
The default value is 0.
Numeric parameter that controls PDP data compression.
0 - OFF (default if value is omitted)
1 - ON (V.42bis, exists for backwards compatibility)
2 - V.42bis
The default value is 0.
Numeric parameter that controls the PDP header compression.
0 - OFF (default if value is omitted)
1 - ON (RFC1144, exists for backwards compatibility)
2 - RFC1144 (applicable for SNDCP only)
3 - RFC2507
Note: Currently, only one data compression algorithm (V.42bis) is provided in
SNDCP. If and when other algorithms become available, a command will be
provided to select one or more data compression algorithms.
The default value is 0.
Example
AT+CGDCONT=?
+CGDCONT: (1-16),"IP",,,(0-2),(0-3)
+CGDCONT: (1-16),"PPP",,,(0-2),(0-3)
+CGDCONT: (1-16),"IPV6",,,(0-2),(0-3)
OK
AT+CGDCONT?
OK
AT+CGDCONT= 1,"IP","internetg","0.0.0.0",0,0
OK
AT+CGDCONT?
+CGDCONT: 1,"IP","internetg","0.0.0.0",0,0
OK
AT+CGDCONT=2,"IP","interpol","0.0.0.0",1,1
OK
AT+CGDCONT?
+CGDCONT: 1,"IP","internetg","0.0.0.0",0,0
+CGDCONT: 2,"IP"," interpol","0.0.0.0",1,1
Deleting a PDP context entry:
at+cgdcont?
+CGDCONT: 1,"IP","","0.0.0.0",0,0
OK