AT Commands Reference Manual - wireless netcontrol GmbH

RS232 Multiplexer Feature
+CMUX, MUX Startup Command
This command is used to activate the MUX protocol stack. Executing a valid +CMUX command,
produces OK result and changes MUX state to MUX-WAIT. If parameters are left out, defaults
are used.
Command Type Syntax Response/Action Remarks
Set
+CMUX=
[,[,[,[,[,[,
[,[,]]]]]]]]
OK
or:
+CME ERROR:
The Set command
requests the H24
to open the MUX
stack with various
parameters. This
command works
only in
MUX-NONE
state.
Read +CMUX? +CMUX: , [],
,, , ,
, +CME ERROR:
Test +CMUX=? +CMUX: (list of supported
s),(list of
supporteds),(list of
supported s),(list of
supported s),(list of
supported s),(list of
supported s),(list of
supported s),(list of
supported s),(list of
supported s)
The Read
command displays
the current mode
and settings. This
command works
only in
MUX-ACTIVE
state.
The Test
Command
displays a list of
supported modes
and parameters.
This command
works in both
MUX-NONE and
MUX-ACTIVE
states.
3-374 H24 - AT Commands Reference Manual April 15, 2010