14.03.2015 Views

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Chapter 3: <strong>AT</strong> <strong>Commands</strong> <strong>Reference</strong><br />

+MPLOG, SW Logging<br />

This command configures the logging channel.<br />

Command Type Syntax Response/Action Remarks<br />

Set +MPLOG= OK<br />

or:<br />

+CME ERROR: <br />

Setting takes<br />

effect after power<br />

cycle.<br />

Read +MPLOG? +MPLOG:<br />

OK<br />

Test +MPLOG=? +MPLOG: <br />

The following table shows the +MPLOG parameters.<br />

Table 3-235: +MPLOG Parameters<br />

Description Remarks<br />

< n > Diagnostic Channel Configuration:<br />

0 - Disable logs<br />

1 - USB<br />

2 - UART1<br />

3 - UART2<br />

Note: Conflicts between MCONN and MPLOG on the UART will cause an error.<br />

Example<br />

<strong>AT</strong>+MPLOG =1<br />

// set the diagnostic over the USB<br />

April 15, 2010 H24 - <strong>AT</strong> <strong>Commands</strong> <strong>Reference</strong> <strong>Manual</strong> 3-377

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!