14.03.2015 Views

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Chapter 3: <strong>AT</strong> <strong>Commands</strong> <strong>Reference</strong><br />

S24, Set Number of Seconds Delay Before H24 Enters Sleep Mode<br />

The terminal sends <strong>AT</strong>S24=5, <strong>AT</strong>+MSLEEP=1 and if there are no radio and UART activities, the<br />

H24 enters sleep mode in 5 seconds.<br />

If terminal has some indication of the CTS pin activity, it can see:<br />

• If +MSCTS=0 (default), the line changes its state upon entering/existing sleep mode.<br />

• If +MSCTS=1, the line is switched off at the moment of entering Sleep mode and stays off<br />

even if H24 is awakened.<br />

(For more information refer to “+MSCTS, Enable/Disable CTS During Wakeup Period” on<br />

page 3-257.)<br />

Command Type Syntax Response/Action Remarks<br />

Set <strong>AT</strong>S24= OK The Set command sets the amount<br />

of time, in seconds, the H24 should<br />

wait before entering Sleep mode.<br />

Read <strong>AT</strong>S24? <br />

OK<br />

The Read command returns the<br />

current value.<br />

The following table shows the S24 parameters.<br />

Table 3-172: S24 Parameters<br />

<br />

Description<br />

Number of seconds (0

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!