AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Alphabetical Summary
+MVC
This AT command is used to choose and configure the
priority order of the supported voice codecs (vocoders).
Page 3-42
+MVREF This command defines the behavior of Vref regulator. Page 3-180
+PACSP
This command shows the Network Selection Menu
availability.
Page 3-152
+TGFCC This command defines RF parameters for signal transmission. Page 3-182
+TPIN
This command queries the number of remaining SIM PIN/PUK
entering attempts.
Page 3-217
+TWFCC This command defines RF parameters for signal transmission. Page 3-186
+VTD This command handles the selection of tone duration. Page 3-199
+VTS
+WS46
A
This command transmits a string of DTMF tones when a voice call
is active.
This command is used to query the current cellular network (Access
Technology selected).
This command answers an incoming call, placing the H24 into the
appropriate mode, as indicated by the RING message.
Page 3-200
Page 3-150
Page 3-18
A/ This command repeats the last command entered on the terminal. Page 3-211
AT This command checks the AT communication and only returns OK. Page 3-211
ATS97
D
This command indicates the status of the antenna physical
connection to the H24 RF connector.
This command places a voice call on the current network, when
issued from an accessory device.
D*99 This command enables the ME to perform the actions necessary for
establishing communication between the terminal and the external
PDN.
D> This command places a voice/fax/data call on the current network
by dialing directly from the H24 phone book.
Page 3-192
Page 3-11
Page 3-297
Page 3-13
DL This command places a voice call to the last number dialed. Page 3-15
E
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
This command defines whether the H24 echoes the characters
received from the user, (whether input characters are echoed to
output).
Page 3-241
H This command hangs up, or terminates a particular call. Page 3-16
I This command displays various H24 information items. Page 3-6
O
Q
RING
This command returns a phone to the Online Data mode and issues a
CONNECT or CONNECT result code.
This command determines whether to output/suppress the result
codes.
This unsolicited event is received when an incoming call (voice,
data or fax) is indicated by the cellular network.
Page 3-39
Page 3-240
Page 3-19
A-10 H24 - AT Commands Reference Manual April 15, 2010