AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
+CLIP Indication
When the CLI presentation indication is enabled by the H24 (=1), this unsolicited indication
is sent to the terminal after the RING indication.
+CLIP:,[,,[,[][,]]]
The following table shows the +CLIP parameters.
Table 3-8: +CLIP Parameters
Description
Enables/disables the CLI presentation indication after the ring indication:
0 Disable CLI presentation
1 Enable CLI presentation
The default is 0.
Shows the subscriber CLIP service status in the network:
0 CLIP not provisioned
1 CLIP provisioned
2 Unknown (for example, no network and so on)
Calling line number. The number format is specified by .
Type of address octet in integer format:
145 Default when the dialing string includes the international access code character
"+".
129 Default when making a local call.
128 Type of number is unknown (usually the output when the number itself is
unknown).
NULL, field not used (String type subaddress of format specified by )
Field not used. Value is always 128 (unknown) - type of sub address octet in integer
format.
Name of the calling party (if provided by the network or if the number is found in the
H24 books).
The Validity of the Calling Line Identity presentation:
0 CLI valid.
1 CLI has been withheld by the originator.
2 CLI is not available due to networking problems or limitations of the
originating network.
Example
AT+CLIP=?
+CLIP: (000,001)
OK
AT+CLIP=1
OK
Example +CLIP indication:
(…incoming call…)
RING
+CLIP: "2173845400",129,,128,"Doe John",0
Example +CLIP indication with restricted CLI:
//CLI presentation is disabled by the H24 (0) and is enabled by the
network (1)
April 15, 2010 H24 - AT Commands Reference Manual 3-21