AT Commands Reference Manual - wireless netcontrol GmbH

GPRS/EDGE/UMTS
+CGQREQ, Quality of Service Profile (Requested)
This command allows the TE to specify a Quality of Service Profile that is used when the UE
sends an Activate PDP Con-text Request message to the network.
Command
Type Syntax Response/Action Remarks
Set
AT+CGQREQ=[
[,
[,
[, [,
[,]]]]]]
OK
or:
+CME ERROR:
Set command specifies a profile for
the context identified by the (local)
context identification parameter,
. As this is the same parameter
that is used in the +CGDCONT
command, the +CGQREQ command
is effectively an extension of the
+CGDCONT command. The QoS
profile consists of a number of
parameters, each of which may be set
to a separate value. A special form of
the set command, +CGQREQ= ,
causes the
requested profile for context number
to become undefined.
Read AT+CGQREQ? +CGQREQ: ,
, ,
, ,
OK
or:
+CME ERROR:
Read command returns the current
settings for each defined context.
Test AT+CGQREQ=? +CGQREQ: ,(list
of supported
s),(list of
supported
s),(list of supported
s),(list of
supported
s),(list of supported
s)
[+CGQREQ:
,(list of
supported
s),(list of
supported s),(list of
supported
s),(list of
supported
s),(list of supported
s)
[…]]
Test command returns values
supported as a compound value. If the
ME supports several PDP types, the
parameter value ranges for each PDP
type are returned on a separate line.
OK
Or:
+CME ERROR:
3-294 H24 - AT Commands Reference Manual April 15, 2010