AT Commands Reference Manual - wireless netcontrol GmbH

Call Control
The format of ATD> command is provided below:
Command
D>[;]
D>mem[;]
Detailed Description
Originates a call to a phone number with the corresponding alphanumeric field
. The Current Phone Book (Set by +CPBS) is searched for the entry that
begins with the alphanumeric pattern .
Originates a call to a phone number in memory (phone book) mem and stored in entry
location . Available memories may be queried with Select Phone Book
Storage Test command +CPBS=?.
Note: This command does not change the used memory set.
D>[;]
Originates a call to a phone number from entry location in the Current Phone
Book (Set by +CPBS).
Note: Current used memory (phone book) set/read is done through the memory command
+CPBS=/+CPBS? respectively.
The following table shows the D> parameters.
Table 3-5: D> Parameters
Description
String type value, which should be equal to an alphanumeric field in a phone book
entry. The used character set should be the one selected with Select Terminal
Character Set +CSCS. is case-sensitive, and should not be placed in quotes.
This parameter is also called "speed dial location". It is an integer type memory
location. should be in the range of locations available in the memory used.
This parameter is not case-sensitive, and should be placed in quotes ("mem").
Example
AT+CMEE=2
//extended errors
AT+CPBS="me"
//Phone flash memory
OK
AT+CPBW=1,"035659090",129,"VoiceMail"
OK
AT+CPBR=1
+CPBR: 1,"035659090",129,"VoiceMail"
OK
AT+CPBR?
+CPBS: "ME",6,500
// test of phone memory's Phonebook
OK
AT+CPBF=""
//list of current Phonebook entrance
+CPBF: 1,"035659090",129,"VoiceMail"
+CPBF: 2,"046750227",129,"jv"
+CPBF: 3,"0576750228",129,"505"
atd>VoiceMail;
//Phonebook by name
OK
OK
3-14 H24 - AT Commands Reference Manual April 15, 2010