14.03.2015 Views

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Reference Manual - wireless netcontrol GmbH

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Chapter 3: <strong>AT</strong> <strong>Commands</strong> <strong>Reference</strong><br />

+MFTM, Factory Test Mode<br />

This command is used to enter and exit FTM mode.<br />

FTM (Factory Test Mode), is a mode where the unit's RF is limited (no camping or searching).<br />

When exiting FTM mode, the unit returns to its normal operation and regains camping.<br />

Command<br />

Type Syntax Response/Action Remarks<br />

Set +MFTM= OK Set the unit's mode.<br />

Read <strong>AT</strong>+ MFTM? + MFTM :< mode >.<br />

Read the current mode.<br />

OK<br />

Test <strong>AT</strong>+ MFTM =? + MFTM: (range of<br />

supported < mode >)<br />

OK<br />

The following table shows the +MFTM parameters.<br />

Table 3-112: +MFTM Parameters<br />

<br />

<br />

0- FTM mode OFF (normal operation).<br />

1- FTM mode ON.<br />

Set FTM mode ON or OFF.<br />

Description<br />

Note: Once +MFTM is issued, one cannot abort the command and <strong>AT</strong> commands are suspended<br />

until +MFTM is returned.<br />

Example<br />

Set command:<br />

<strong>AT</strong>+MFTM=1<br />

+MFTM:FTM_MODE<br />

OK<br />

<strong>AT</strong>+MFTM =0<br />

+MFTM:FTM_MODE_OFF<br />

OK<br />

Test command:<br />

<strong>AT</strong>+MFTM =?<br />

April 15, 2010 H24 - <strong>AT</strong> <strong>Commands</strong> <strong>Reference</strong> <strong>Manual</strong> 3-181

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!