AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
Example
AT+CLIR=?
+CLIR: (0,1,2)
OK
AT+CLIR?
+CLIR: 1,4
AT+CLIR=1
OK
atd054565195;
//MO voice call
OK
(… calling …)
(… a H24 that has 054565195 SIM and is CLIP enabled will receive the following on the terminal:
RING
+CLIP: "",128,,128,"",1
RING
+CLIP: "",128,,128,"",1)
ath
NO CARRIER
OK
AT+CLIR=0
OK
atd054565195;
//MO voice call
OK
(… calling …)
(… a H24 that has 054565195 SIM and is CLIP enabled will receive the following on the terminal:
RING
+CLIP: "054565006",129,,128,"",0
RING
+CLIP: "054565006",129,,128,"",0 …)
ath
NO CARRIER
OK
+MDC, Selection of Desired Message to Be Displayed Upon
Connection of a Voice Call
This AT command enables you to select the desired messages to be displayed upon connection of
a voice call with a remote party. The OK and CONNECT messages are available.
Command Type Syntax Response/Action Remarks
Set +MDC= OK
or:
ERROR
The Set command selects which of the
supported messages will be displayed
upon connection of a voice call.
Execute AT+MDC OK The Execute command selects the
default (OK) message.
April 15, 2010 H24 - AT Commands Reference Manual 3-33