AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
Phonebook and Clock
Directory Access Commands - Phone Book
This set of commands enables read/write access to the phone book contained within the H24,
including both the numeric and the alpha information contained in the location. The presentation
is according to GSM 07.07.
In some cases, it may be possible to use these commands to access the dialed and received call
stacks. However, as these phone books cannot be edited, the +CPBW command does not work on
them.
+CPBS, Select Phone Book Memory Storage
This command handles the selection of the memory to be used for reading and writing entries in
the H24’s phone books’ memory. (When there is separate storage on the SIM card and in the
H24’s internal EEPROM).
Command
Type
Syntax Response/Action Remarks
Set
AT+CPBS=
[,]
OK
or:
+CME ERROR:
Set command selects phonebook
memory storage , which will
be used by other phonebook
commands.
Execute AT+CPBS OK Execute command selects the default
phonebook memory storage.
Read +CPBS? +CPBS:
[,,]
OK
Test +CPBS=? +CPBS: (list of
supported s)
OK
Read command returns currently
selected memory, number of used
locations and total number of locations
in the memory.
Note: Read format of +CPBS joins RC and MC, therefore the united list will be prompted.
April 15, 2010 H24 - AT Commands Reference Manual 3-65