AT Commands Reference Manual - wireless netcontrol GmbH

Appendix A: Reference Tables
+CRC
+CREG
This command controls whether to present the extended format of
the incoming call indication.
This command enables/disables the network status registration
unsolicited result code.
Page 3-19
Page 3-128
+CRING This unsolicited event indicates the type of incoming call. Page 3-19
+CRLP This command displays the Radio Link Protocol parameters. Page 3-127
+CRSL
+CRSM
+CRTT
This command sets the different alerts volume level of the active
audio mode.
This command provides limited access to the Elementary Files on
the SIM.
This command plays one cycle of a ring tone, stops the cycle in the
middle, and sets the ring tone to be used.
Page 3-194
Page 3-271
Page 3-198
+CSCA This command handles the selection of the SCA and the TOSCA. Page 3-75
+CSCB
This command handles the selection of cell broadcast message types
and data coding schemes received by the H24.
Page 3-111
+CSCS This command selects the H24 character set. Page 3-4
+CSDH This command shows the Text Mode parameters. Page 3-84
+CSIM
This command allows a direct control of the SIM by a distant
application on the TE.
Page 3-273
+CSMP This command sets the Text Module parameters. Page 3-82
+CSMS
This command handles the selection of the SMS message service
type.
Page 3-90
+CSQ This command displays the signal strength received by the H24. Page 3-126
+CSSN
+CUSD
+EPIN
+FCLASS
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
This command handles the enabling and disabling of supplementary
service-related, network-initiated, notifications.
This command allows control of Unstructured Supplementary
Service Data (USSD), according to GSM 02.90.
This command is only relevant for phones that use SIM cards. It
verifies the PIN2 indicator.
The H24 facsimile service maintains a parameter for identification
and control of facsimile services.
Page 3-48
Page 3-51
Page 3-216
Page 3-58
+FMI This command displays manufacturer identification. Page 3-1
+FMM This command displays the model identification. Page 3-2
+FMR This command displays the revision identification. Page 3-3
+FRH
+FRM
This command causes the H24 to receive HDLC framed data using
the modulation mode selected in , and deliver the next
received frame to the terminal.
This command causes the H24 to receive data from the remote party
using the modulation specified in .
Page 3-64
Page 3-62
April 15, 2010 H24 - AT Commands Reference Manual A-5