AT Commands Reference Manual - wireless netcontrol GmbH

Hardware Information
+MIOI, Motorola GPIO Interrupt configuration
This command supports the H24 8 GPIO pins configuration as interrupt lines.
Command
Type Syntax Response/Action Remarks
Set
AT+MIOI=,[],
[< active_state>]
OK
or:
+CME ERROR:
The set command enables/disables the
selected IO pin to react as an interrupt.
Note: +MIOI setting overrides
+MIOD configuration.
i.e. A line previously
configured as output by
+MIOD, will be reconfigured
to input upon setting it as an
interrupt line by +MIOI.
The change will be reflected in
+MIOD read command.
Read +MIOI? +MIOI:
< pin selection >, <
debounce_time >
< notification_type >
OK
Test +MIOI=? +MIOI: (list of
supported s),(list of
supported <
debounce_time>s),(list of
supported < active_state
>s)
OK
The test command returns the possible
ranges of:
s,
s,
and < active_state >s.
3-176 H24 - AT Commands Reference Manual April 15, 2010