AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 3: AT Commands Reference
Error Handling Commands
+CMEE, Report Mobile Equipment Error
The Set command disables or enables the use of result code +CME ERROR: as an
indication of an error relating to the functionality of the H24. When enabled, H24-related errors
cause a +CME ERROR: final result code instead of the regular ERROR final result code.
Usually, ERROR is returned when the error is related to syntax, invalid parameters or terminal
functionality.
For all Accessory AT commands besides SMS commands, the +CMEE set command disables or
enables the use of result code +CME ERROR: as an indication of an error relating to the
functionality of the H24. When enabled, H24 related errors cause a +CME ERROR: final
result code instead of the regular ERROR result code.
For all SMS AT commands that are derived from GSM 27.005, the +CMEE Set command
disables or enables the use of result code +CMS ERROR: as an indication of an error
relating to the functionality of the H24. When enabled, H24-related errors cause a +CMS
ERROR: final result code instead of the regular ERROR final result.
Command
Type Syntax Response/Action Remarks
Set AT+CMEE=[] OK
or:
+CME ERROR:
Read AT+CMEE? +CMEE:
OK
Test AT+CMEE=? +CMEE: (list of
supported s)
OK
The Set command enables or disables the
use of result code +CME ERROR: as
an indication of an error relating to the
functionality of the H24.
The Read command returns the current
setting format of the result code.
The Test command returns values
supported by the terminal as a compound
value.
The following table shows the +CMEE parameters.
Table 3-176: +CMEE Parameters
Description
0 Disable the +CME ERROR: result code and use ERROR.
1 Enable the +CME ERROR: or +CMS ERROR: result codes and
use numeric values.
2 Enable the +CME ERROR: or +CMS ERROR: result codes and
use verbose values.
The default value is 0.
April 15, 2010 H24 - AT Commands Reference Manual 3-259