AT Commands Reference Manual - wireless netcontrol GmbH

Access
Example
AT+MGSMSIM?
+MGSMSIM: 1
OK
AT+MGSMSIM =?
+MGSMSIM: 0-1
OK
AT+MGSMSIM=0
OK
Personalization Commands
This section lists the set of commands that handle the Personalization feature. The commands:
+CPIN, +CLCK and +TPIN are common to the personalization as well as to other locking
facilities of the H24 and therefore will only be referred from this section to their location in this
document. +MPERSO is the only personalization specific command and will be detailed right
below.
When the module is personalized, the only accessory operations allowed are Core AT commands
(allowed while H24/SIM card is locked). All other AT commands are not executed. For example,
accessing phone book entries. However, the module is still capable of sending asynchronous
message events via AT responses, for example, incoming call notification.
+MRPERSO - Restore Configuration From Backup
This command restores the configuration of personalization from a backup partition and
overrides the existing configuration if exits.
Command
Type Syntax Response/Action Remarks
Set +MRPERSO= OK
The following table shows the +MRPERSO parameters.
Table 3-150: +MRPERSO Parameters
Description
8 is the only valid value.
3-226 H24 - AT Commands Reference Manual April 15, 2010