AT Commands Reference Manual - wireless netcontrol GmbH

Network
+WS46, Get Wireless Network
This command is used to query the current cellular network (Access Technology selected).
Access Technology is selected by +COPS Set command (see parameters of AT+COPS).
Command
Type Syntax Response/Action Remarks
Read AT+WS46?
OK
or:
+CME ERROR:
Test AT+WS46=? +WS46: (list of
supported s)
OK
or:
+CME ERROR:
The following table shows the +WS46 parameters.
Table 3-90: +WS46 Parameters
Description
Selected Access Technology
12 GSM Digital Cellular Systems (GERAN only)
22 UTRAN only
25 3GPP Systems (both GERAN and UTRAN)
Note: These 3 values are mutually exclusive. e.g. if value "25" is returned, value "12"
and "22" shall not be returned.
Note: AT command WS46 indicates the networks in which H24 can operate.
When manual registration was performed with selecting of particular access technology
(GERAN/UMTS), +WS46 Read command returns code 12 for GERAN access
technology or code 22 for UMTS access technology.
When automatic registration or manual registration without selecting of particular access
technology was performed, +WS46 Read command returns code 25(both GERAN and
UMTS technologies are available). Actually, the return code of +WS46 Read command
indicates the user preference for the RAT rather than the mode MT is operating in.
Example
AT+COPS?
+COPS: 0,0,"IL Cellcom",2
OK
AT+WS46?
25
3-150 H24 - AT Commands Reference Manual April 15, 2010