AT Commands Reference Manual - wireless netcontrol GmbH

SMS
+CSMS, Select Message Service.
This command handles the selection of messaging . It returns the types of messaging
services supported by the H24.
Command
Type
Syntax Response/Action Remarks
Set +CSMS= +CSMS:
,,
or:
+CMS ERROR:
Read +CSMS? +CSMS:
,,,
The Set command sets the type of
service and returns the types of
messages supported by the H24.
The Read command returns the
supported message types along with
the current service setting.
Test +CSMS=? +CSMS: The Test command returns a list of all
the services supported by the terminal.
The following table shows the +CSMS parameters.
Table 3-52: +CSMS Parameters
Description
0 Acknowledge (RP-ACK) for incoming SMS-Deliver and SMS-Status-Report
is sent immediately when those messages arrives H24 and +CNMI parameter =2
or/and =1. =0 is default value.
1
• Acknowledge (RP-ACK) for incoming SMS-Deliver or SMS-Status-Report
may be sent via acknowledge command +CNMA when SMS-Deliver or
SMS-Status-Report messages arrives H24 and +CNMI parameter =2
or/and =1. In case acknowledge command +CNMA is not given within
required time an error (RP-ERROR) is sent to network.
• In case network support & text mode: service center time stamp is added to
+CMGC, +CMSS and +CMGS commands report.
In case network support & pdu mode: ackpdu (network SUBMIT-Report without SC
address) will be added to +CMGC, +CMSS and +CMGS commands report.
Mobile terminated messages
0 Not supported by the H24
1 Supported by the H24
Mobile originated messages
0 Not supported by the H24
1 Supported by the H24
Broadcast type messages
0 Not supported by the H24
1 Supported by the H24
3-90 H24 - AT Commands Reference Manual April 15, 2010