AT Commands Reference Manual - wireless netcontrol GmbH

Chapter 1: Product Features
Fax Class 1
Fax Commands
+FCLASS
Table 1-1: AT Commands (Cont.)
AT Command Description Page
The H24 facsimile service maintains a parameter for identification
and control of facsimile services.
Page 3-58
+FTS This command causes the H24 to stop any transmission. Page 3-59
+FRS
+FTM
+FRM
+FTH
+FRH
This command causes the H24 to wait for silence and to report back
an OK result code when silence has been present on the line for the
specified amount of time.
This command causes the H24 to transmit data to the remote party
using the modulation selected in .
This command causes the H24 to receive data from the remote party
using the modulation specified in .
This command causes the H24 to transmit data framed in the HDLC
protocol, using the modulation mode selected, to the remote party.
This command causes the H24 to receive HDLC framed data using
the modulation mode selected in , and deliver the next
received frame to the terminal.
Page 3-59
Page 3-60
Page 3-62
Page 3-62
Page 3-64
Phonebook and Clock
Directory Access Commands
+CPBS
+CPBR
+CPBF
+CPBW
This command handles the selection of the memory to be used for
reading and writing entries in H24s that contain more than one
phone book memory.
This command recalls phone book entries from a specific entry
number, or from a range of entries.
This command searches the currently active phone book for a
particular entry, by name.
This command stores a new entry in the phone book, or deletes an
existing entry from the phone book.
Page 3-65
Page 3-67
Page 3-69
Page 3-70
System Date and Time Access Commands
+CCLK This command reads/sets the H24's current date and time settings. Page 3-72
SMS
SMS Commands
+CSCA This command handles the selection of the SCA and the TOSCA. Page 3-75
+CPMS
This command handles the selection of the preferred storage area for
messages.
Page 3-79
+CMGF This command handles the selection of message formats. Page 3-80
+CSMP This command sets the Text Module parameters. Page 3-82
+CSDH This command shows the Text Mode parameters. Page 3-84
April 15, 2010 H24 - AT Commands Reference Manual 1-21