AT Commands Reference Manual - wireless netcontrol GmbH

Call Control
AT+CRC=?
+CRC: (0-1)
OK
Example - RING/+CRING indication
(..Incoming Data Call..)
RING
RING
RING
AT+CRC=1
//Enable extended ring format
OK
+CRING: REL ASYNC
+CRING: REL ASYNC
ath
AT+CRC=1
OK
//Mobile fax call terminated (multi-numbered scheme) from PSTN
fax machine
+CRING: ALT Voice/Fax
NO CARRIER
OK
+CLIP, Calling Line Identification
This command controls the Calling Line Identity (CLI) presentation indication to the terminal
when an incoming call is detected by the device.
This command allows the user to query the provisioning status of the CLI by the network and by
the device. The command also allows the user to enable/disable the CLI presentation by the
device to the terminal.
The +CLIP indication information varies depending on what is provided by the network and what
information is stored in the device phone book.
Command
Type
Syntax Response/Action Remarks
Set AT+CLIP= OK
Or:
+CME ERROR:
The Set command enables or disables
the presentation of the CLI indication
from the device to the terminal.
Note: The Set command does not
address the network.
Execute AT+CLIP OK The Execute command set default
+CLIP state (disable).
Read AT+CLIP? +CLIP: ,
OK
Test AT+CLIP=? +CLIP: (list of supported
s)
OK
The Read command returns the +CLIP
enable/disable state in the device as
well as in the network provisioning
state of the CLI presentation.
The Test command returns the Set
command options (0,1).
3-20 H24 - AT Commands Reference Manual April 15, 2010