AT Commands Reference Manual - wireless netcontrol GmbH

AT Commands Summary
+CRC
RING
This command controls whether to present the extended format of
the incoming call indication.
This unsolicited event is received when an incoming call (voice,
data or fax) is indicated by the cellular network.
Page 3-19
Page 3-19
+CRING This unsolicited event indicates the type of incoming call. Page 3-19
+CLIP
+CCWA
+CHLD
Table 1-1: AT Commands (Cont.)
AT Command Description Page
This command controls the Calling Line Identity (CLI) presentation
to the terminal when there is an incoming call.
This command controls the Call Waiting supplementary service,
including settings and querying of the network by the H24.
This command controls the Call Hold and Multiparty Conversation
supplementary services.
Page 3-20
Page 3-22
Page 3-24
+CCFC This command controls the call-forwarding supplementary service. Page 3-29
+CLIR
+MDC
+CBST
O
+CR
+MVC
+MTTY
This command enables/disables the sending of caller ID information
to the called party, for an outgoing call.
This AT command enables you to select the desired messages to be
displayed upon connection of a voice call with a remote party.
This command handles the selection of the bearer service and the
connection element to be used when data calls are originated.
This command returns a phone to the Online Data mode and issues a
CONNECT or CONNECT result code.
This command controls whether or not the extended format of an
outgoing or incoming data call is displayed or not.
This AT command is used to choose and configure the
priority order of the supported voice codecs (vocoders).
This command is used to enable/disable the TTY (Tele Typewriter)
support in the H24.
Page 3-31
Page 3-33
Page 3-36
Page 3-39
Page 3-40
Page 3-42
Page 3-43
Call Status Messages
+CPAS
+CLCC
This command displays the current activity status of the H24, for
example, call in progress, or ringing.
This command displays a list of all current H24 calls and their
statuses, and also enables/disables the unsolicited indication of the
call list.
Page 3-45
Page 3-45
Supplementary Services
+CSSN
+CUSD
+COLP
This command handles the enabling and disabling of supplementary
service-related, network-initiated, notifications.
This command allows control of Unstructured Supplementary
Service Data (USSD), according to GSM 02.90.
This command refers to the GSM supplementary service COLP,
Connected Line Identification Presentation, which enables a calling
subscriber to get the connected line identity (COL) of the called
party after setting up a mobile-originated call.
Page 3-48
Page 3-51
Page 3-55
1-20 H24 - AT Commands Reference Manual April 15, 2010