AT Commands Reference Manual - wireless netcontrol GmbH

A-GPS
The following table shows the +MPNMEA parameters.
Table 3-228: +MPNMEA Parameters
Description
NMEA path configuration:
0 - None (no NMEA channel).
1 - USB.
2 - For future use.
3 - UART2 (default).
Example
AT+MPNMEA=3
OK
// Set MNMEA output path to UART2 Serial Port
A power cycle of the H24 is required now.
+MNMEA, Start/Stop NMEA
Set command starts/stops NMEA messages.
The start operation starts the GPS receiver and an endless GPS position fix session starts. The fix
information is reported as an NMEA message every 1 second.
The Stop operation stops the GPS receiver and also the NMEA stream.
Command Type Syntax Response/Action Remarks
Set AT+MNMEA = OK
or:
+CME ERROR:
Read AT+MNMEA? +MNMEA:
OK
Test AT+MNMEA=? +MNMEA: (list of supported<
action >s)
The following table shows the +MNMEA parameters.
Table 3-229: +MNMEA Parameters
Description
0 - Stop (default)
1 - Start
Note: When AT+MNMEA session is started, AT+MGPSLOC set command is not allowed.
Example
AT+MNMEA=1
OK
// Start GPS Position Fix session, NMEA Streaming
// NMAEA Streaming
3-366 H24 - AT Commands Reference Manual April 15, 2010